Category Archives: My radios

My radios

QRP SDR трансивер M0NKA mcHF

Проект разработки Chris M0NKA

Features
Standalone and compact embedded transceiver
Continues RX coverage 1.8-30 Mhz
5-10W output power
CW, SSB, AM and FM – transmit and receive
300/500 Hz CW and 1.8/2.3 kHz SSB filters with adjustable passband centering
3.6 kHz “wide” filter plus 5, 6, 7.5 or 10 kHz “extra wide” filters for SSB/AM reception
SSB/AM Transmit Speech processor
DSP noise reduction
DSP automatic notch filter
Spectrum scope
Waterfall Display
Highly configurable with a wide variety of menu items
Weight 700g

null

Создание и обсуждение на форуме

TA4/US7IGN 2016

Мне всегда нравилось отношение к жизни моего друга и учителя Леонида UT2II, который берет в отпуск жену и радио. Я поступил так же и отдых удался!

Continue reading

5$ Arduino based CW KEY

Как с минимальными затратами времени и денег получить автоматический ямбик для полноценный работы в эфире, если нет обычного манипулятора, а в трансивере нет автоматического ключа?

Continue reading

CF210SP

Обещал дочери на день рождения подарить конструктор что-нибудь спаять. Выбор пал на китайский DIY KIT CF210SP.

Continue reading

Kenwood PS-430

The Kenwood PS-430 power supply provides 13.8 VDC at 20 amps intermittent (25% duty cycle), 15 amps standard (50% duty cycle) or 10 amps maximum at continuous load. Ripple voltage is less than 20 mW at 13.8VDC 15 A. Input is 120/220/240 VAC 480W. The power supply employs a 6 amp AC fuse and 20 amp DC fuse. The rear panel has a hard-wire Kenwood power cable to connect directly to the TS-430S. There are also “plus” and “minus” terminal outputs (10 amps max). The rear panel has a fan. A snap-down tilt bail is featured on the bottom panel to increase the operating angle. 6.8 x 3.75 x 9.675 inches 15.4 Lbs. (7 kg).

Continue reading